Calling all rotax 914'ers! So today was very chuffed to be moving onto a new
part
of the manuel, hanging the engine. However ran into a problem straight away.
The lower STBD bolt, that they tell you cut to 95mm and grind a flat in the
head, How do you get it in????? Firstly now iv trimmed it to 95mm, once the nut
is on, there is 1/2 to 1 tread poking out but more importantly when you try
to put it in from above the turbo the angle it is as there is no way its going
in! The curved casting of the turbo keeps the bolt at an angle. Any input is
appreciated. Many thanks Frank
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=455086#455086
|