I just used a card gauge for the angle (which isn't that critical and would be
better if slightly less)
bolted them together using the rod end and washers and wired them to the pipe
using
locking wire round the pipe and rod end.
If I did it ever again; I would move them 3mm toward Port as its a bit tight for
the nut against the tank recess for no good reason.
Didn't have any issue with getting the nut on - tie wrapped a spanner to a rod.
Flight testing my Tru trak Gemini now.
--------
Graeme Bird
G-UMPY
Mono Classic/XS FFW 912S/Woodcomp 3000/3W
Newby: 200 hours 4 years on the Mono
g@gdbmk.co.uk
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=453224#453224
|