Hi Paul
Use a short length of tube with a larger diameter than the lug as a
reaction point on the back face of the prop flange to allow the lug to
be drawn into position using a threaded rod with plate washers behind
the nuts. Don=99t what ever you do hit it with a hammer and
don=99t trim them either.
Best of luck
Richard
From: Paul & Vanessa Munford
Sent: Monday, May 4, 2015 6:37 PM
Subject: Europa-List: Prop drive lugs
Hi to all,- hope you can help. Trying to fit drive lugs (x6) into prop
flange ?? 1) They are very very tight & I'm worried about getting them
halfway in & then not being able to take them out again ??? 2) How do
you put enough force on them anyway? - you cannot tap them in from the
back as the gearbox is in the way ? Is there a special clamp to draw
them in ( can't use a normal G-clamp)? Should they be lightly trimmed to
ease their fitment??? Thankyou in advance. Paul Munford Kit 625 NG
trigear
|