PaulI used a short bolt (with the same thread of course) and a larger socke
t bit and a washer to draw them in.It helps to soak them in a freezer too.G
raham
On Monday, 4 May 2015, 18:39, Paul & Vanessa Munford <pmdental@btinter
net.com> wrote:
Hi to all,- hope you can help. Trying to fit drive lugs (x6) into prop fl
ange ?? 1) They are very very tight & I'm worried about getting them halfwa
y in=C2- & then not being able to take them out again ??? 2) How do you
=C2-put enough force on them anyway? - you cannot tap them in from the ba
ck as the gearbox is in the way=C2-? Is there a special clamp to draw the
m in ( can't use a normal G-clamp)? Should they be lightly trimmed to ease
their fitment??? Thankyou in advance. Paul Munford Kit 625 NG trigear=C2-
=C2-=C2-
|