I've looked on this forum and Internet to find an answer to this question as I'm
sure this will have been asked before but I'm unable to find an answer.
The build manual refers to the old design where you drill tp10 sleeves o ensure
minimum/zero lateral movement of the torque tube. However the new design has
pre drilled tp10 plastic sleeves . Therefore no mechanism to remove end float
by sizing the tp10 sleeves. I can only assume that this has be achieved during
the bonding of tp11 bearings.
The new torque Tube is not referenced in the build manual and I can find no
modification
that introduces it. Am I missing something?
Alan
[Question]
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=428671#428671
|