Gidday,
Im stuck and was hoping someone could resurrect my momentum. I need to know how
long to make my instrument panel studs to accommodate a washer, possibly
conical,
and probably only on the cockpit side, as the other side should use either
metal or phenolic washers. This means I am having permanent studs out the back
of the panel, going through the firewall, and being secured on the engine
compartment
side of the firewall. Im going to use AN3 bolts, with their heads Reduxed
onto the brackets I have incorporated into the internal flange over the
top and along the bottom horizontal edge of the back of the panel. Sourcing of
appropriate and recommended suppliers for these washers appreciated, as I dont
seem to easily be able to source them at home.
Lastly, I was going to research the US supplier for all sorts of small bits and
pieces of hardware, but I cant remember it for the life of me, nor can my brains
trust.
Thanks.
Regards
Tony Renshaw
Sydney Aussie.
|