Hi Rob
Hmm, it looks to me like if you put a some scotch-tape around the nut and jammed
in either a box wrench or socket it may work?
If you were to use 1/4" socket with lots of extensions and universal/s could you
get to the bolt?
If not how about using a short, medium or long box wrench? If not, then buy a
cheap
box wrench, cut, heat up and bend if needed and weld on an extension, or
use a box wrench you have and bend up a metal bar and use hose clamps to hold
it?
Since you are in there, get some inspection lacquer and mark the jam nut for the
ball fitting.
Ron Parigoris
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=419236#419236
|