Andrew...given that "bulkhead's" fasteners called for in the manual,
I've never thought it had much structural significance...functioning
more to confine divets, turf, etc. forward of the fuel valve than do
much else. That is, however, pure conjecture on my part.
Fred
A194
On Jul 30, 2011, at 9:41 PM, Andrew Sarangan wrote:
> >
>
> For the center console bulkhead, I was wondering if it would be better
> to build a curved bulkhead that follows the curvature of the wheel
> well rather than the flat plywood panel suggested in the manual. This
> means the new bulkhead will be further forward than the suggested 8"
> from the seat back face. I wasn't sure if this would introduce any
> problems in the future. Any thoughts?
|