If anyone has an XS monowheel sitting on a factory-supplied trailer
with wings stowed for travel, a yardstick and measuring tape, and a bit
of spare time, I have a request. Could you please:
1. Establish a waterline at the bottom door sill, extending aft from
the rear edge of the door about 18 inches.
2. Measure down 10".
3. Record the distance from the side of the fuselage at that point out
to the surface of the wing.
In the interest of drag reduction, I've been working on a fuselage/wing
fillet which mates w/ the standard XS wing fairing just forward of the
spar. Of necessity, a portion of this fillet will be attached to the
wing, a portion to the flap, and a portion to the fuselage. I am trying
to establish the location of the joints, and the extent to which the
portion attached to the fuselage can extend beyond the surface of the
fuselage without impacting the wing when trailering is the big unknown.
A few pixs below explain the general form this fillet is taking
Your assistance would be much appreciated.
Fred
A194
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|