Just wondering if anyone has done anything special with their door handles
with regard
to steamlining. I was looking at the flush mount ones from ACS that are used
on the liberty
but worry they will be too deep to fit in the door. I was thinking that a
blended fillet
starting at the front of the door coming out about 20mm high and deep then
blending back in about 2/3 the
way along the door with the handle set into this so it is effectively flush
with the skin of the door.
I have seen the "aerofoil" shaped handles which would be my next choice.
regards
craig
Checked by AVG.
2:31 PM
|