If you are creative you could make a simple but effective one, using two
clear solid tubes of PVC
and a couple of light plastic balls with a restrictor on one end and the
hose attached to the other
suck a vacuum on both lines and adjust the restrictor so the balls rise in
the tube the same amount so you know
it is reading the same on both tubes.
we used one of these (glass tubes) on older race bikes to tune the carbs to
get the mixtures equal.
The carb tune system mentioned my stephan looks much the same
craig
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of Martin Tuck
Sent: Tuesday, 19 February 2008 1:47 PM
Subject: Europa-List: Carburetor Synchronization
Hi Folks,
I watched with interest the Rotax-owner.com video on carburetor
synchronization.
Anyone know where one can get the single dial (dual pointer) sync tool
shown on the video.
Lockwood only seem to sell the dual dial version.
Any other tools out there one can use?
Regards,
Martin Tuck
Europa N152MT
Wichita, Kansas
6:49 PM
6:49 PM
|