Bob,
Thanks for the reply. I'm going at it the same way.
I had not looked at build web page for some time. Thanks for all the
good info...
Kevin
rlborger wrote:
> Kevin,
>
> FWIW, I routed the power wiring from the panel, down the starboard
> side under the door sill and straight back along the fuselage through
> the baggage bay bulkhead and on to the power supply. I did this
> because all my antenna cables route under the port door sill and I
> wanted to keep the antenna wires as far as possible from the power
> wiring. I run the power from the power supply to the wings under the
> baggage bay floor and out the front into the "well" area between the
> baggage bay front and seat back. From there through the fuselage into
> the wing root area. I then connect the wiring to trailer wiring plugs
> as recommended by 'Lectric Bob Nuckolls. You can go to my build web
> page, thence to the last album (Y6 Q4 2007), page 2 bottom for pics of
> the external setup. This shows where the wiring exits the fuselage
> and the connectors used there and on the wing roots.
>
> There are additional pics of the internal set-up in earlier build albums.
>
> Let me know if you need further clarification.
>
> Good building and great flying,
> Bob Borger
> Europa Kit #A221 N914XL, XS Mono, Intercooled 914, Airmaster C/S
> http://www.europaowners.org/N914XL
> (90%) tail kit done, wings closed, cockpit module installed, pitch
> system in, landing gear frame in, rudder system in, outrigger mod in,
> Fuselage Top on, lift/drag/flap pins in, wing incidence set, tie bar
> in, flap drive in, Mod 70 done. Baggage bay in. Flaps & Main Gear
> complete. Mod 72 complete. Instrument panel complete, except for
> testing. Rotax 914 installed (for the 3rd time). Airmaster Prop
> installed. Electrical complete, except for testing. Fuel system
> complete except for testing. Working in - 32 Tail, 34 Door Latches &
> 35 Doors, 37 Interior & Finishing. Airmaster arrived 29 Sep 05. Seat
> arrived from Oregon Aero. E04 interior kit has arrived and is being
> installed.
> 3705 Lynchburg Dr.
> Corinth, TX 76208
> Home: 940-497-2123
> Cel: 817-992-1117
> On Dec 23, 2007, at 11:07 AM, Kevin Klinefelter wrote:
>
>> <kevann@gotsky.com <mailto:kevann@gotsky.com>>
>>
>> Hi All,
>> I have installed Whelen strobe and position lights on the wingtips of
>> my XS mono. I installed the strobe "box" under the baggage bay. Now I
>> need to wire it from the wing root to switches on the panel and to
>> the strobe box in back.
>>
>> I am looking for advice on where in the fuse at the wing root to
>> route the wiring. The wires come out of the wing root aft of the
>> spar. I have a space under the door sill to route wires. I am just
>> trying to decide on a good method and placement for the connection at
>> the wing root, and routing the strobe cable back to the box.
>>
>> Happy Holidays, Kevin
>> A211 XS 914 mono. Getting closer to flight!
>
>
> *
>
>
> *
|