Hi Ferg
I fitted the MAP sensor to the interior Firewall, Then used a bulkhead
pipe fitting to carry the vacuum through the firewall using Silicone
Vacuum pipe to the cross balance pipe between carburetors, Can send you
a picture if needed,
Regards
Ivor
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Fergus Kyle
Sent: 01 December 2007 15:47
Subject: Europa-List: Dynon EMS-D10/Rotax914
Cheers,
This is directed to those having the above combination
installed:
I am wondering how you attached the MAP sensor to the engine
successfully. I particular, if the sensor is on the source of remote and
if
the latter, what material you used to connect the two. I am fussing over
inherent heat and vibration problems.
Much obliged in expectation,
Ferg
|