All,
I wonder if Poly Fiber's Tubeseal can be used as well as a substitute for
the ACF50. It says on the container
" containing a very fine preservative oil, mil spec. l-21260, which has a
characteristic of climbing the tube wall and spreading over the entire
surface to provide lasting protection. Prevents rust and corrosion inside
aircraft tubing structures."
Another set of questions:
The instruction of Mod 72 states:
" Thoroughly coat the insert with etch primer, including the bore, and allow
to dry completely."
I am not sure about :
A- How do you uniformly coat the inside of the inserts (and probably the
inside of the tubes too) ?
B- Don't you scrape the primer off again when you drive the insets into the
tubes and therefore make the coating useless?
Wonder how others have done this.
Regards
Michael Grass
A266 Trigear, 914, Woodcomp3000
Detroit
----- Original Message -----
From: "Graham Singleton" <grahamsingleton@btinternet.com>
Sent: Thursday, August 09, 2007 7:45 PM
Subject: Re: Europa-List: Mod 72
> <grahamsingleton@btinternet.com>
>
> Waxoil? it's an old motor trade product.
> Graham
>
> William Daniell wrote:
>> <wdaniell@etb.net.co>
>>
>> Ok is there a commonly available substitute for both remembering that
>> bringing hazmat from the US to Colombia is a little costly?
>> Thanks
>> Will
>>
>
>
>
|