Hi! Jerry
That's how it is now with new wires. BTW They are no longer bullets but
long skinny thin spades. "No Kill" Prevails .....Me'thinks why the
change ?
Regards
Bob Harrison G-PTAG
Robt.C.Harrison
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Jerry Rehn
Sent: 31 July 2007 23:11
Subject: RE: Europa-List: New 914 won't "kill" on either ignition
circuit....
Don't you just hate when this happens?
Lastly I would insert an alligator clip (with connecting wire to
another
clip) into the grounding Connection right at the module insuring a good
connection with that bullet connector (That is inside that protective
sleeve) then connect the other end to the manifold or other handy metal
engine part. Forget about switches for now. Maybe you've tried this
already
but if you do this and get spark, well then I would suspect the wire at
the
ignition module, could you have pulled on the connector bullet and
pulled it
loose from the wire? Usually when you hear of ignition modules being
defective, it causes the engine not to start or to run rough not your
situation. Good luck.
Jerry
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
R.C.Harrison
Sent: Tuesday, July 31, 2007 2:31 PM
Subject: RE: Europa-List: New 914 won't "kill" on either ignition
circuit....
<ptag.dev@tiscali.co.uk>
Hi! David, Gilles, Jerry.
Thanks for your responses.
I now have two new mag kill wires direct from the mag connectors to the
mag groundings (just to prove it isn't my wires or switches) The plugs
|