Have a few T-Bar questions (drive tube for antiservo tabs):
1) How much clearance between T-Bar and drive horns (side to side) you
leave?
2) Has anyone installed some sort of tension-er to prevent vibration of
this side to side clearance? (perhaps a 3/4 pound #10 round nose plunger)
3) When making the stabilators work, in either positive or negative angle
of attack, is the aerodynamic force pulling the tips of the stabilators
forward? (like the tips of wings are pulled forward)
4) Has anyone bent or broken the antiservo drive pin/horn by perhaps a
bird strike, someone pushing on the stabilator backwards, perhaps because
there was not enough side to side clearance?
5) Anyone have any critters crawl into their plane through the T-Bar slot
in the fuse?
6) Anyone use anti critter covers for this slot? Or?
Thx.
Ron Parigoris
|