Marty
That is a "Bummer"
I had to look it up in my manual to figure out what stops you were talking
about.
The new version of the manual has it clearly illustrated on pages 12M-3 and
12T-3. For all you "older kit" builder, the new manual has both Mono and
Trigear
in the same binder.
I have a bent frame you could have that you could take measurement of. I had to
replace my Mono frame when I made my "bad" landing.
Cliff Shaw
1041 Euclid ave.
Edmonds, WA 98020
425 776 5555
http://www.europaowners.org/WileE
----- Original Message -----
From: Marty Mason
To: europa-list@matronics.com
Sent: Sunday, November 06, 2005 9:49 AM
Subject: Europa-List: Landing gear mounting frame
Hello List,
After having most of my metal parts powder coated I discovered that KW screwed
me again. I am building a Monowheel and have a TriGear landing gear mounting
frame. This is the one without over center (centre) stops. Is there anyone out
there who is planning to build a Tri or Conventional gear that would trade their
landing gear mounting frame with over center stops for a newly powder coated
(white) frame?
You can contact me off list.
Marty Mason
A291 Mono Short Wing
Plan 914 w/Airmaster CS
10%? done
Norcross, GA 770-448-6469
captainmarty@bellsouth.net
|