Yes, I had to cut in a reversed V in the stainless to get the movement.
Dean Seitz
N284A XS High Top Tri Gear 914 Airmaster CS.
20 hrs so far
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Mike Gamble
Subject: Europa-List: rudder pedal movement
With the rudder pedals lined up in the neutral position I see that the CS21
arms are about vertical.
The stb arm can move aft a little way before striking the side piece of the
stainless steel firewall but the port arm will very soon contact the upper
s/steel panel. Do people find that there is sufficient movement availabe
here as right rudder is applied or is bending/cutting of the s/steel panel
required?
Thanks
Mike Gamble
XS 440 mono
|