:-) Thanks, Jos - I've had the Dremel suggested, but the heat shrink -
that's a new one and a very good suggestion! :-)
Cheers,
Jeremy
Jeremy Davey
Europa Monowheel 537M G-EZZA
Europa Club Vice-Chairman, Webmaster, PFA NC Representative
PFA EC Member
If you can keep your head when all about you are losing theirs, then it is
possible you haven't grasped the severity of the situation.
Tail done
Standard XS wings with mods underway
CM installed in fuse (with airbrakes fittings)
1390 build hours to date
Intended fit:
Rotax 914 turbo, Airmaster CS fully-feathering prop
Lots of lights, buttons, switches, gizmos, and alarms
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Jos Okhuijsen
Subject: Re: Europa-List: Swaging those cables
Hi Jeremy,
Oh, this is an easy one... Diamond cutting wheel in the Dremel, no
pressure applied and just let it sink through. This keeps the strands in
place.
I used this paper paint edge tape, or nothing, because taking it off might
disturbe the strands. Put a bit of heatshrink on first , and after the
swaging use this to make nice, finger sparing ends.
Regards
Jos Okhuijsen
Jeremy Davey <EuropaFlyer_3@msn.com> kirjoitti Fri, 29 Apr 2005 01:12:18
+0100:
>
> Possibly an apposite question given the current debate on Mod 70=85
>
> I=92m doing the rudder cables on =91ZA. I=92ve not done the TP18 cables
> because I
> was aware they would likely not be required =96 so this is my first
> attempt at
> fitting the collars and thimbles.
>
> How on earth do you get the cable through those collars? There has to be
> =91a
> trick=92 that I don=92t know!! It=92s proving a nightmare of frayed
> cable ends and
> rolls of insulating tape.
>
> Regards,
> Jeremy
>
> Jeremy Davey
> Europa Monowheel 537M G-EZZA
> Europa Club Vice-Chairman, Webmaster, PFA NC Representative
> PFA EC Member
> =93If you can keep your head when all about you are losing theirs, then
> it is
> possible you haven't grasped the severity of the situation.=94
> Tail done
> Standard XS wings with mods underway
> CM installed in fuse (with airbrakes fittings)
> 1390 build hours to date
> Intended fit:
> Rotax 914 turbo, Airmaster CS fully-feathering prop
> Lots of lights, buttons, switches, gizmos, and alarms
>
>
--
Using M2, Opera's revolutionary e-mail client: http://www.opera.com/m2/
|