Europa-List: Radiator Fitting

[John Cliff <mx@crixbinfield.freeserve.co.uk>]

Fitting the radiator (coolant heat exchanger) to the fabricated cooling duct,
the book says
"The radiator is bolted to the side platesof the cooling duct by two AN3-5A
bolts and MS21042-4(?) nuts each side."

Offering the radiator up inside the duct leaves a total gap (sum of both ends)
of about 18mm between radiator ends and duct side plates.  Have other people
found this ?  If so did you use tubular spacers on longer bolts to fill the
gaps, or something more elaborate ?

John Cliff
#0259