Gidday,
I have a Rotax engine mount that has needed a welding repair, and now I
have mated it to my landing gear mount in an attempt to mount a Graham
Singleton phenolic firewall. The mount has the 4 legs sticking forward, and
the top 2 are the ones with the bracing. The bottom ones have none. This is
contrary to how I would have imagined it to be. The installation picture
Graham provided me has reinforcing bracing on the one of the bottom legs,
the port one as I recall, braced back toward the weld attach point of the
Starboard leg. So, what sort of engine mount have I actually got, and what
sort is the one in Grahams picture???? Standing by.....
Reg
Tony Renshaw
Sydney Australia
Classic 236 B.B. Taildragger
Currently working on Rudder Pedals,
In but tight so more work to go on them.
Tail, Wings, Ailerons, Flaps Complete and Connected
Lower Fuse in Jig,
Tail Torque Tube installed with temporary timber dowels.
Mass Balance assembly installed and deflections sorted
Roof Panel between doors completed.
Photos at:
http://forum.okhuijsen.org/TonyR
Intended Engine: 912S CS prop (model undecided)
Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
Horizon, one that I can trust for short periods IMC, to get out of a sticky
situation
|