David Hi!
> I mounted the mass balance arms on the ailerons according to the specs in the
> manual before I got the information that they probably would not line up in
> the joggles on the wings before I did this. So, do I need to cut the arms
> off and start over (I hope not) or is it O.K. to trim the edges of the covers
> and move them off center to fit over the arms? Other solutions?
Had the same problem. Move the Boxes and make good any new joggles you have
to make. Extra strength is given to boxes when you fit Top skin.
Dont touch the Ailerons!
Regards
Gerry
Europa 384 G-FIZY
Trigear with Rotax 912 and Arplast CS Prop.
Engine very near to starting.
Painting completed. Vinyl design scheme to be added.
Completing Wiring to Panel.
Dynon EFIS, KMD 150, Icom A-200 and SL70 Transponder. AoA Fitted.
Shoulder Width Mod. Heater Unit constructed and fitted.
http://www.g-fizy.com
+44 7808 402404
gnholland@onetel.com
|