europa-list
[Top] [All Lists]

Re: trim tab damper assembly

Subject: Re: trim tab damper assembly
From: Andy Draper <andy@europaaircraft.com>
Date: Tue, 7 May 2002 12:33:20
Dear Richard,

The correct force that the friction damper should resist is 5kg +0/-1kg at 
90degrees
to the long arm (the one that the servo attaches to).

Best Regards
Andy Draper

Technical Director
e-mail   andy@europa-aircraft.com


>>> "Richard Iddon" <riddon@btinternet.com> 05/06/02 02:45pm >>>
I have just put together the trim tab (anti servo) damper assembly which
connects to the servo unit.  I have no experience of this but it seems very
tight to me.  With the end of the drilled bolt only just through the nyloc
nut, I can only just move the damper asembly up and down the slot with my
thumbs. Is this right?  I was wondering if the servo unit could handle the
amount of force needed to move it.

Richard Iddon (XS Tri 533)



<Prev in Thread] Current Thread [Next in Thread>