Re: powder coating

[Bob Harrison <ptag.dev@ukonline.co.uk>]

Hi! Jeff.
I'm no metallurgist but 400 degrees may or may not be a problem for steel
but it could possibly en-brittle aluminium.
Bob Harrison  G-PTAG

-----Original Message-----
From: forum-owner@europaclub.org.uk
Subject: Re:  powder coating


Roger.
    The heat is only 400 degrees for only about 20 minutes.
    Jeff

Roger Mills wrote:

> 2 helpful companies who do powder coating are:-
>
> Batchglow (at Dinnington near Worksop) (01909 563 051)
> Danum Light Industries at Doncaster (01302 854531)
>
> Bear in mind that powder coating is a heat treatment process and may
> affect the strength of the metal - it might be advisable to check
> suitability!
>
> Regards
> Roger Mills
> 141