You must have had a different batch - I ran the bolts through so many times
that all the Cd plating is gone and the dumb hole still looks square and is
visibly smaller than the bolt!
Best regards,
Rob
PS, you answered a rhetorical question :-)
-----Original Message-----
Behalf Of Tony Krzyzewski
Subject: Re: Avionics & panel depth
This mount has the added advantage of using the nut
> plates in their intended orientation rather than inverted (!) per the
> manual - rhetorical question: has anyone been able to put a bolt into
> one of these nutserts from the wrong end? With the normal exit end
pinched to
> smaller than the bolt diameter, that is not possible with any of the
> nutserts delivered with my kit.
I used the ones supplied with the kit. Before you rivet the nut plate in
place
thread a bolt in from the proper side a couple of times. This will give just
enough slack to allow you to insert the bolt from the wrong side when you
come
to mount the servo.
Tony
|