> OK, so I've filled my bins with little parts and sorted the big parts
> that the little parts will hold together to make even bigger parts, but
> some parts remain aloof, enigmatic...ah, hell, I can't figure out what
> they are! <g>
I had the same problem. I was marking off all the ones that I identified on
the inventory list, so I figured out the remaining ones by looking at the
6 or so items that were not marked off!
> First off is three airfoil like shapes, diminishing in size from nearly
> 2 feet, to 20 inches, to 17 inches, respectively. They appear to be
> moulded fibreglass. Each has a flat side, the opposite side has an inch
> deep lip. Their front looks like a nice leading edge, the trailing
> edges are notched.
These go into the fin to stiffen it.
> Our second contestant is an elongated diamond shape, slightly
> asymmetrical, approx. 19 inches long and 2 3/4 inches high at the
> peaks. It has the same moulded appearance and one inch depth as the
> above items. One side note: each long end's tip has a notch or tooth,
> but I can't tell if this is by design or a result of an improper
> release from the mould.
I don't recognize this one! Do I have it? Should I have it?
Brian
|