>>Do you mean the cut is radial making a slit from the outside edge of the
>>grommet to the hole in the grommet on a line thru the center of the hole or
>>do you really mean tangent to the hole which would cut a notch out of the
>>grommet.
>
Not radially . . . the bundle or tube being protected can wedge itself
into the cut and spread the grommet material. Pressure against the
tangental cut tends to close the slice . . . not open it.
>
> Sorry to question, but describing this in words is difficult and
> I want to get this right.
>
No problem. I've put a sketch up on our website describing the
technique at:
<http://www.aeroelectric.com/grommet.pdf>
Bob . . .
AeroElectric Connection
////
(o o)
< If you continue to do, >
< What you've always done, >
< You will continue to be, >
< What you've always been. >
|