So I did get them in the right place :-)
Interestingly enough the manual doesn't explicitly state that.
Tony
#272
------------------------
From: Graham Singleton <100421.2123@compuserve.com>
Subject: Re: Ailerons
Date: Thu, 26 Jun 1997 10:50:20 +1200
> >> I realise now that replacing these hinge pins in the future will be a
pig of
> a job.<<
>
> Not that bad. As Roger has pointed out the pins should lie centredon the
outside
> edge of the flange. Just adjust the cut outs till they line up. Then make
my
> little jig { ;-)
>
> Graham
>
>
---------------End of Original Message-----------------
---------------------------------------------------
Tony Krzyzewski tonyk@kaon.co.nz
Managing Director Ph 64 9 358 9124
Kaon Technologies Fx 64 9 358 9127
Auckland
New Zealand
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/272index.html
----------------------------------------------------
|