europa-list
[Top] [All Lists]

Re: Plywood (3mm) piece identification

Subject: Re: Plywood (3mm) piece identification
From: Europa <enquiries@europaaviation.co.uk>
Date: Wed, 25 Jun 1997 08:49:29
>About to cut out the 70mm square plywood pieces for the spar bush
>reinforcement, I suddenly realized I haven't the foggiest idea which ply
>piece to cut them from!
>I have 7  3mm plywood pieces left, labeled F06,2,3,4,6&7, with no hint as to
>where each of them is destined.  I don't wish to cut up anything that I will
>need later.  The fuselage manual's Annex A-3 (Fig. 1. 3mm Plywood /Cutting
>Plan) is no help, as there are no dimensions, and it seems to be obsolete as
>it presupposes 2  760 mm squares supplied, and I have instead a number of
>various sized rectangular pieces.
>
>How about it, Andy?  Am I missing something?  Is there a key to where these
>pieces are supposed to be used?
>
>Pops
>A-36
>
Your bits of plywood should be used as follows:-

F06              Rear bulkhead

Ply-2            Thigh support ribs (3 off)
                     Headrests (2off)
                     Rudder pedal floor (2 off)

Ply-3             Spar pin bush reinforcements (these are  the ones you need 
at the moment)

Ply-4             Elevator mass balance guide / limit stop             

Ply-5             Fuel tank supports (2 off)
                     Fuel selector valve mount  (1 off)
                     Spar pin latches (1 off) 

Ply-6             Fin rear close out

Ply-7             Tunnel bulkhead behind main wheel

Regards

Roger Bull


____________

                  Address for Europa Aviation technical back-up is    
enquiries@europa-aviation.co.uk



<Prev in Thread] Current Thread [Next in Thread>