Hi Bruno
If you bend down static port after you remove bullet so it is at a 45 degree
down
angle there is a chance you may get some usable AOA information when at Factory
position. As mentioned in my album it is too far aft for optimal performance
because the true airflow will have become distorted because too much wing
is upwind (in other words airflow will begin to follow the bottom of the wing).
If it is unacceptable you can move both the static and AOA (old pitot) to
position
shown in my album. BTW that position was carefully chosen and allows for
pitot/ AOA tubes to somewhat be protected when wing is on Factory trailer.
Ron P.
BTW be very careful grabbing the tube for bending, you can easily crush it.
Visit - www.EuropaOwners.org
|