Does any Bid get laid up from the horizontal floor to the fuselage sides?
P.28-11 just says "Also layup 2 plies of 'bid' each side of the join between
the fuselage and the rear baggage bay bulkhead, lapping them onto each by
25mm (1")."
Not sure if that includes the horizontal portion...
Thx
Paul 383 Mono XS
CM in, working on bottom(!)
-----Original Message-----
From: Neville Eyre
Subject: Re: Europa-List: Baggage Bay Questions
Hi Mike,
The baggage bay floor sits 3/4'' [19mm] above the tailplane pushrod, at the
same angle, put a piece of scrap timber that thick on top of the pushrod,
and trim the outer edge of the floor, and the rear bulkhead so there is no
pressure on to the inside of the fuselage. Then bond in with Redux under the
overlapping flange to the lower bulkhead, and 2 ply Bid from the panel to
the fuselage, [ both sides of the upper ''D'' shape bulkhead.] Cheers, Nev.
|