>I seem to recall reference to a mod involving the reversing of the screws
>attaching the pitch trim motor and the floxing of them in postition to
>effectively make "studs", allowing for future removability of the motor.
>Was this in an early edition of "Europa Flyer"? Has anyone done this, or
>can remember where it was published?
In issue 4 of the Europa Club Newsletter David Dufton suggested attaching a
plate with andchor nuts to the rear of the bulkhead so that the fixing
screws could go through the trim motor, then the bulkhead and into the
anchor nuts.
Dave Watts 'XDY
|