Hi guys, Where do you think I should put the EIS water/coolant temperature sensor? I'm thinking in the long hose that runs from the radiator to the 'distributor pot' on top of the engine. Regards, Ma
I have done without a coolant temp for years so I'm inclined to agree. I'm also tired of looking at at a row of blanks for coolant temp on my EIS. Just looking to get a reading on the display. Martin
Hi Folks, I'm changing out the rubber engine mounts and performing Mo 72. I had a terrible job getting the split pins out of the two lower engine mounting bolts. I was thinking, is there anything pre
Thanks John, they must have changed the manual at some point. I would have used the first set of instructions ( pre-official manual). Martin Sent from my iPad direction, as they are fore-aft the 'nor
I'm busy rehanging the engine with fresh rubber mounts. Is there an easier way of compressing the rubber mounts such that you can get the threads of each bolt to show through enough to put the washer
Thanks Jonathon, The instructions say that the four AN5-40 mounting bolts must be tightened fully to compress the rubber anti-vibration mounts (MT04) onto the steel spacers MT03. That is the compress
Thanks all for suggestions. I managed to get them all done tonight using a combination of tie wraps and a small clamp along with longer bolts to compress the rubbers first. Then replaced each one wit
I recently went to a baseball game and visited the concession stand. I asked for a drink. "What size?". "Just a small will do" I replied. "We don't do small - only medium, large or extra large". Only
Hi Folks, Doing my annual condition check and flipped the right wing over to get to the aileron bellcrank and noticed my center flap hinge (the one on the flap) has pulled out about 1/32nd of an inch
Europa Hi John, I have a copy somewhere. Let me know if you find one closer to home - otherwise I'll dig it out and you can borrow it. I probably can't scan it as it is likely still copyrighted. All
I was watching a Dynon video on installing servo stops and noticed that the servos seem very stiff. If two are in the (pitch and roll) system doesn't that stiffen up the nice light control responses
Does anyone know where I can find a red float ball I can install in the sight gauge fuel line? Regards, Martin Tuck Europa N152MT Sent from my iPhone the fuel valve between the seats. Ill assemble th
I don't run the sight gauge down near the foot wells, instead I run it up the center tunnel on up on the passenger seat side into the passenger headrest to the vent. Martin Sent from my iPhone monowh
Hi folks, My daughter videoed me landing my Europa and I ran it though Premiere Elements and uploaded to You Tube. https://youtu.be/I_OWsld__i0 Regards, Martin Tuck Europa N152MT
Hi Remi, You show quite a bit more rubber sticking out either side than I see on mine, are you sure the outer large washers are fully clamped between the spacers? The rubber mounts don't seem fully c
Sounds like a plan, definitely send them back to Europa for examination. Martin Sent from my iPad today. I hoisted the engine and surprisingly the rubber mounts did not come back to their symetrical