Hi guys,
After some hit and miss starting, I finally gave in and bought two new
ignition modules which I installed today.
Engine burst into life immediately upon starting.
The only problem is that when I do a 'mag' check, the engine runs fine
on one 'mag/module' but the engine stops when I switch to the other.
I will recheck my wiring of course particularly yellow and white wires
to the ignition coils (which I had to think about which was which but
I'm pretty sure I got them going to the correct white wires coming out
of the coils).
I have the 'old style' 4-pin plug modules.
I'm open to ideas on what else I might check.
regards,
Martin Tuck
N152MT
Wichita, KS
|