on 3/12/02 11:49 AM, John & Amy Eckel at eckel1@comcast.net wrote:
> Hi all,
> I am about ready to separate the antiservo tab from the tailplane.
> Does anyone have a slick method for doing the angled cut
> on the bottom?
>
> Thanks,
> John, A230
Hi John, I just completed that operation several months ago. I used a Dremel
with a thin cut off wheel and angled the wheel to the direction of the slot.
It worked well with only a few small dings to the tab leading edge. It does
take a steady hand and a well marked line to follow outlining the slot. Good
luck. John K. A046
|