Three questions:
1) The manual says to assemble the rudder pedals proir to installation 'to
chech they are straight'. Anyone got any ideas what to do if they are not?
Ours are not quite straight, not by much but enough to make them very stiff
once the tufnol bushes are bolted into place - a little gentle presuasion
perhaps?
2) Again instructions are to set up the rudder pedals on to the floor then
lay up BID with the pedals insitu - seems like a tricky layup. Can't see
what's wrong with positioning the floors using the pedals, bonding them
with rapid epoxy then removing the pedals prior to laying up the BID floor -
any thoughts.
3) A while ago someone posted something about installing a set of car
pedals - anyone got any more details?
Thanks in anticipation
Paul Stewart #432
|