I made supports/cradles from eps
William Daniell
LONGPORT
+57 310 295 0744
On Thu, May 21, 2020, 05:55 Tony Renshaw <tonyrenshaw268@gmail.com> wrote:
>
>
> > Gidday,
> I am considering post curing my tailplanes, ailerons and flaps and am
> wondering if people believe I should support the trailing edges, I
=99m very
> happy with how straight they are at the moment, and I don=99t want
to wreck
> them. I have T shaped aluminium straight edges I could use with double
> sided tape to stabilise them, or do people believe with 50 degrees for 15
> hours it should be materially stable already and should just boil off the
> hardener? Any advice or suggestions about supporting these components wou
ld
> be appreciated, even whether I can simply prop them up so air can get
> completely around them, without any hotspots. I=99m concerned even
whether
> having them rest on specific hard points could be an issue at 50
> degrees.... personally I think not, but I don=99t want to find out
the hard
> way.
> Regards
> Tony Renshaw
>
> >
>
===========
===========
===========
===========
===========
>
>
|