What caused them is to shear, and what can be done to prevent recurrence?
> On Jul 19, 2019, at 3:28 AM, Mike Kelly <mike@dommi.plus.com> wrote:
>
>
> Thanks everyone for helping.
> What we found is that 4 very small screws had sheared off the end of the
> gear train housing, allowing the motor & gearbox assembly to rotate and snap
the supply wires to the motor.
>
> Now we are faced with the task of removing these small screws from the gear
> housing
and making good again.
>
> Will let you know when we are back up and running again. :?
>
> --------
> MK
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=490417#490417
>
>
>
>
>
>
>
>
>
|