That spinner bulkhead, the grey disc on the front of the black cylindrical
housing,
very often doesn't fit tightly/firmly/snugly enough into the actual spinner
and there is a small gap of maybe 0,1 mm between the grey plastic disc and
the inside of the metal spinner.
After many hours of use, when you take the spinner off for some reason, you
might
find grey powder/dust inside the spinner and a witness mark inside the spinner
where the grey plastic disc rubs against it.
So I usually wrap a few (3 or 4?) short lengths (5 cm each?) of electrical
insulation
tape across the edge of the plastic disc at equal intervals around the
edge of the disc, before putting the spinner back on.
How does anyone know if there is a gap? If the spinner goes on too easily before
inserting the screws which attach it to the rear bulkhead/ disc, then there
is probably a small gap. So if there are first a few pieces of tape around the
edge of the front grey plastic disc, then a small push against the front of the
spinner is needed before it is possible to insert the fastening screws in the
rear bulkhead.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=489087#489087
Attachments:
http://forums.matronics.com//files/airmaster_spinner_5_156.jpg
http://forums.matronics.com//files/airmaster_spinner_4_131.jpg
http://forums.matronics.com//files/airmaster_spinner_3_475.jpg
http://forums.matronics.com//files/airmaster_spinner_2_864.jpg
http://forums.matronics.com//files/airmaster_spinner_1_425.jpg
|
