That is a very useful piece of information. I think I have enough that it
won't matter if I wipe of a lot of excess.
On Thu, Jan 25, 2018 at 3:53 PM, William Daniell <
wdaniell.longport@gmail.com> wrote:
> My experience is that you need to lay it on thick in the middle of the
> bond and then ensure that it squeezes out the sides. This avoids having
> voids in the bond. I spent quite a lot of time with a high power light, a
> 1/8 drill and a syringe after my first bonds.
>
> Will
>
> William Daniell
> LONGPORT
> +57 310 295 0744
>
> On Wed, Jan 24, 2018 at 8:05 PM, Graeme Hart <graeme.hart@onecoolkat.com>
> wrote:
>
>> No I mean 6 kits. I don't know what a quart is in terms of weight but
>> the "Part A" of the packs I have is 1kg which is about 2.2 pounds.
>>
>> I'd rather have too much than too little as the cost of shipping exceeded
>> the cost of the adhesive and the cost of shipping was largely independent
>> of the amount of adhesive I was shipping (due to dangerous goods paperwork,
>> special packaging, handling etc)
>>
>> If I was in your position I'd take the risk and just go ahead with the
>> adhesive you have and consider ordering more once the cockpit is in and one
>> wing is closed.
>>
>> It does seem like I've got an excessive amount of adhesive so I may have
>> some to sell in a year or so.
>>
>> On Thu, Jan 25, 2018 at 12:00 PM, n7188u <chmgarb@gmail.com> wrote:
>>
>>>
>>> Thanks,
>>>
>>> I assume that by six cans you mean 3 quart kits. I was told 3 quarts is
>>> what is supplied in the kit. I am hoping to get a very rough estimate of
>>> the amount needed for the three stages I mentioned. Just in terms of half
>>> can, quarter can, etc.
>>>
>>> Sounds like a weird request but it will help me keep the cans closed
>>> until the moment they are needed (this stuff is like gold so might as well
>>> keep it as such!).
>>>
>>> Chris
>>>
>>>
>>>
>>>
>>> Read this topic online here:
>>>
>>> http://forums.matronics.com/viewtopic.php?p=477552#477552
>>>
>>>
>>>
>>>
>>>
>>>
>>> ==========
>>> pa-List" rel="noreferrer" target="_blank">http://www.matronics.com/
>>> Navigator?Europa-List
>>> ==========
>>> FORUMS -
>>> eferrer" target="_blank">http://forums.matronics.com
>>> ==========
>>> WIKI -
>>> errer" target="_blank">http://wiki.matronics.com
>>> ==========
>>> b Site -
>>> -Matt Dralle, List Admin.
>>> rel="noreferrer" target="_blank">http://www.matronics.com/contribution
>>> ==========
>>>
>>>
>>>
>>>
>>
>
|