Hi All
Just fitted the Tri Gear main wheels to the main gear legs for the first time.
However, the slotted main axle nut spins on so far that it is completely clear
of the pre-drilled split pin hole. Picture attached.
Anyone else have this problem?
I assume the answer is to drill a new hole for the split pin but how easy will
that be in the hardened steel axle.
I have a pillar drill and some cobalt drills but have experienced problems with
hardened steel before.
Any advice on a solution?
--------
Regards
Kelv Weston
Kit 497
kelv@kdweston.biz
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=448386#448386
Attachments:
http://forums.matronics.com//files/axle_117.jpg
|
