Hi All
Have just tried fitting the brake caliper mounting plates MG02 to the main gear
legs and found that the holes for the AN5 bolts do not align.
One leg is quite close and would probably go after a bit of fettling, but the
other
leg is half a hole out.
Has anyone else had this problem?
I have checked the alignment of the drilled holes on the problem leg and both
the
mounting bolt hole at the top of the leg and the axle hole are vertical when
the leg is laid on a flat surface, so that's ok.
The problem looks like the hole in the axle for the torque plate mounting bolt
has not been drilled on the centreline. This can be seen in the second picture.
--------
Regards
Kelv Weston
Kit 497
kelv@kdweston.biz
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=439135#439135
Attachments:
http://forums.matronics.com//files/dscf1096_997.jpg
http://forums.matronics.com//files/dscf1099_657.jpg
|
