Hi,=0APV50 -If you find your problem is the pitch-change motor and you find
a supplier then I would like to have the details so that I can buy a spare
.=0AIt is possible to fit a resistor in the pink supply wire to the motor.I
t is 2 ohms-10W-RS part no:252-2489.=0AI love the Arplast/Smart Avionics pr
opeller/controller system.It does take time to understand and setup correct
ly,particularly the coarse pitch setting to allow a reasonable climb rate o
n a go around.=0AI suspect that the micro switches may also need changing i
n time and even could be your problem. I have fitted the recommended mechan
ical stops on the pitchchange screw to limit pitch runaway in case of switc
h- or screw failure!- =0A-=0ACheers Ken Atkinson G-CEKV- =0A=0A___
_____________________________=0A From: Gerry Holland <gholland@content-stre
am.co.uk>=0ATo: europa-list@matronics.com =0ASent: Friday, 8 November 2013,
6:07=0ASubject: Re: Europa-List: Arplast PV50 problem=0A =0A=0A=0AJim Hi.
...It's Gerry.=0AWhere is FIZY at moment? I'm quite happy to come down and
take a look if that's of use.=0AAs you know i'm SW of Bath. If you are stil
l at Thruxton then it's very doable.=0ALet me know.=0ARegards=0AGerry=0A=0A
=0AGerry Holland=0Agholland@content-stream.co.uk=0A+44 (0)7808 402404=0A=0A
White Ox Mead Airstrip, Bath. England
|