Hi Pete,
I can see from your photo that these white wires are not pushed fully home.
You will notice that each of the other wires in the plastic multi connector
shows two black/dark coloured parallel strips just inside where they enter
the connector block. These are water seals. If you now look at your two
offending white wires these strips do not look the same because they are not
fully pushed home.
So the answer to your question is to push them further in. You will find
that they pop into place when in the correct position and should then look
like the other wires.
Give it a try, think you will find this fixes your problem.
Pete
_____
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Peter Field
Sent: 24 November 2012 10:39
Subject: Europa-List: Electrics
Does anybody know what retains the cables pushed into the terminal block
(see photo)? The ignition circuit kill wires are the two white cables and we
have had some trouble with these not making a good connection. There are
rubber grommets that fit around the wires and appear to be the only means of
securing a contact by applying pressure to the cable when fitted inside the
block.
Peter Field. G-CHOX
_____
No virus found in this message.
Checked by AVG - www.avg.com
|