There has been several other recent emails of good advice already.
Make sure you have all your needs on hand, brief your team carefully before
starting.
JR (Bob) Gowing Kit327 in Oz
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of bill mcclellan
Sent: Friday, 22 June 2012 5:44 AM
Subject: Europa-List: Re: bonding fuselage top
Paul, some suggestion, do it with your room as cool as possible to give the
process as much time without the glue going off. Rehearse the process first
with several helpers. Don't try to mix the whole amount in one
batch/container so as to be too hard to handle. If you have glued with
redux before, you know how thick to get the glue with the flox. It is
important not to be too thin or too thick. You probably aren't but don't
use screws as they suck the skins down too tight leaving an indentation at
each screw which has to be filled later. Scrape off extra glue that oozes
out of seam but don't unduly disturb the fuselage skins in doing so.
Bill
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=376242#376242
-----
No virus found in this message.
Checked by AVG - www.avg.com
|