europa-list
[Top] [All Lists]

Re: Europa-List: Hole Enlongation vs. Landing Gear Type

Subject: Re: Europa-List: Hole Enlongation vs. Landing Gear Type
From: RobNeils <RobNeils@qwest.net>
Date: Mon, 25 Jun 2007 08:20:04
N128HW, a tri-gear motorglider, is operated out of a grass strip (WN92, 
Spokane, Washington).  The tailplane is tight across all parameters 
after 150 hours of engine time.
  ----- Original Message ----- 
  From: TELEDYNMCS@aol.com 
  To: europa-list@matronics.com 
  Sent: Monday, June 25, 2007 6:18 AM
  Subject: Europa-List: Hole Enlongation vs. Landing Gear Type


  Greetings team,

  As I read through the various theories of why the pin holes elongate 
I'm left with a question that nobody seems to be asking (or maybe 
somebody did ask and I missed it).

  This is a little out of my area of expertise, but it seems rational to 
me that either a mono or a conventional gear Europa, i.e., one with a 
tailwheel, would transfer significantly more stress loads to the 
components in the rear of the aircraft, thus leading to more wear on 
everything back there. By contrast, the trigear would dampen those 
stress loads by virtue of the main gear being a considerable distance 
---From the parts in question, thus damping any forces transferred to the 
tail area. Stresses transferred by a trigear would further be damped by 
the spring action of the main gear legs and the tires (tyres).

  Has anyone ever correlated pin wear to landing gear type? Are there 
more mono's and conventional gear Europa's showing pin wear and or hole 
elongation than trigears?

  In my case, N245E, a trigear, now has a bit over 100 hours TT. About 
90% of the take offs and landings thus far have been made from my grass 
strip and my pip pins are still tight as a tick. I have observed no 
increased play in the tailplanes and only a slight amount of play in the 
trim tabs and that hasn't changed since day one. I've also looked 
closely at all the hardware in the tail and I cannot detect any wear on 
any components whatsoever. I know this is anecdotal at best, but it 
seams reasonable for those in the know to correlate pin wear to landing 
gear type as they chase down the root cause of the wear that caused the 
tailplane flutter.

  Regards,

  John Lawton
  Whitwell, TN (TN89)
  N245E - Flying


-------------------------------------------------------------------------
-----
  See what's free at AOL.com. 



<Prev in Thread] Current Thread [Next in Thread>