I completed Mod 70 today. Not a pleasant pastime but that=B9s life!
One piece of learning was when replacing new TP18 the following instruction
is given:
The adjuster TP18C has two flats machined - this will assist in fitting the
unit to the hole in TP9.
It has been found that it is best to fit the lower bolt first.
Good advice but it helps if you fit a bolt temporarily into top hole
initially. It allows you a pivot point that helps locate bottom bolt. Once
the bottom bolt is located then remove upper bolt and continue as
instructed.
The centering of mass balance is marginal so I may or may not refit guide
cables. I cut them outboard so they could be reused.
It=B9s an awkward job but with patience it all works out OK.
Regards
Gerry
|