tank fittings
fittings
Jeremy,
About those rudder cables, sleeve them with Poly flo, or the other similar
fuel line material in the Spruce catalogue.
Reg
Tony Renshaw
Sydney Australia
At 08:10 PM 2/23/2005, you wrote:
>
>Having fitted my Singleton tailwheel bellcrank, I=92m now looking at how to
>arrange the autopilot pitch servo =96 so I rigged up the flap drive tube and
>some string for the rudder cables. The rudder cable runs seem VERY close to
>the fuel tank fittings =96 and I was wondering if anyone else had had this, or
>is there some way of ensuring they don=92t contact?
>
>Regards,
>Jeremy
>
>Jeremy Davey
>Europa Monowheel 537M G-EZZA
>Europa Club Vice-Chairman, Webmaster, PFA NC Representative
>PFA EC Member
>=93If you can keep your head when all about you are losing theirs, then it is
>possible you haven't grasped the severity of the situation.=94
>Tail done
>Standard XS wings with mods underway
>CM installed in fuse (with airbrakes fittings)
>1320 build hours to date
>Intended fit:
>Rotax 914 turbo, Airmaster CS fully-feathering prop
>Lots of lights, buttons, switches, gizmos, and alarms
>
>
|