Tony,
Mine were stiff also and I had to dismantle the cylinders and clean
quite a lot of leftover grinding paste out of them. I too would like to
know who the manufacturer is.
Richard Iddon. G-RIXS
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Tony
Renshaw
Subject: Europa-List: Europa Finger Brake Master Cylinder Brand????
--> <tonyrenshaw@optusnet.com.au>
Gidday,
I have a Europa dual cylinder master cylinder for finger brakes, but it
is not stamped with a manufacturers name, and therefore I cannot find
out what type of lubricant is OK to put down the bores to loosen things
up, and also for the future I'd like to find out who can supply seals,
and how to gain access to them. So, any ideas???? Anyone else who has
installed these in a Classic module, I'd like to hear from.
Reg
Tony Renshaw
Sydney Australia
Classic 236 B.B. Taildragger (possibly convertible)
Tail, Wings, Ailerons, Flaps Complete and Connected
Lower Fuse in Jig, Tail Torque Tube installed
Mass Balance assembly installed and deflections sorted
Intended Engine: 912S CS prop (model undecided)
Instrumentation: Undecided
|