Terry, Many thanks for that. I have replaced all my interior hosing (original from Europa) with fuel injection hoses, now about to replace all the exterior line and engine lines. Causes a fuel smell
Jim and Heather, Congratulations on the first flight, well done. Hope the leather boots fit in well and add some protection. Cheers, Tim Tim Ward 12 Waiwetu Street, Fendalton, Christchurch, 8005 New
Richard, --From memory I used a bolt and slid some rubber hose onto it to soften the bump. Cheers, Tim Tim Ward 12 Waiwetu Street, Fendalton, Christchurch, 8005 New Zealand. Ph +64 3 3515166 Mobile 0
Justin, Excellent work. Well put together and a good reminder. Haven't done it yet(taxying that is) but always wary of it due to the small distance between prop and ground. Cheers, Tim A332 Propeller
Jeff, Bob Archer Antenna I have, mounted on the inside/starboard/ 1 meter behind 'D' bulkhead/ of the fuselage. Secured to the fuselage with Velcros. Works perfectly!! Cheers, Tim Tim Ward 12 Waiwetu
According to my children, who now observe every aircraft flying in the sky, the Europa is by far the most quiescent. Tim Ward 12 Waiwetu Street, Fendalton, Christchurch, 8005 New Zealand. Ph +64 3 35
Dan The spacer goes through the latch to decrease friction and allow the latch to free fall in the down position. (in theory) The other spacer rests against the lever 'edge' in the down or up positio
Retract lever safety spring Tim Ward 12 Waiwetu Street, Fendalton, Christchurch, 8005 New Zealand. Ph +64 3 3515166 Mobile 021 0640221 ward.t@xtra.co.nz -- Original Message -- From: Gavin & Anne Sent
Troy, I had no problem regarding space (Monowheel Classic) for the Skydrive carb heater.The 'cold air induction mod' I presume is the plenum air chamber that Europa supplied. My plenum air chamber is
David, No, I don't have the Microsoft Small Business Server system only Windows XP Home with no additives. Hope this helps. Tim Tim Ward 12 Waiwetu Street, Fendalton, Christchurch, 8005 New Zealand.
Hi Europaeans, Fixed the Regulator/Rectifier problem. Had the unit checked out by a Rotax agent here and all was OK. So back to tracking it down with the voltmeter. Before re-installing the DIN plug
Welcome back Tony and well said. I certainly agree regarding the performance of the Airmaster prop and the highly professional development and back up service. Cheers, Tim Tim Ward 12 Waiwetu Street,
David, Likewise, I changed all my fuel piping. The company issue is of very bad quality and permeates easily to create a fuel smell in the cockpit and eventual seepage. I eventually used marine fuel
Andrew, Adjust the aileron bell crank settings to get the required displacements. I think the manual does mention this at the end. Cheers, Tim Tim Ward 12 Waiwetu Street, Fendalton, Christchurch, 800
To Europaians; I have available again the above products for your Europa. View them on the Matronics Photo Share website; http://www.matronics.com/photoshare/ward.t@xtra.co.nz.11.22.2003/ Cheers, Tim
To Europaians; I have available again the above products for your Europa. View them on the Matronics Photo Share website, Europa List. Cheers, Tim Ward 12 Waiwetu Street, Fendalton, Christchurch, 800
Richard, Go down to your local hardware shop, in the plumbing division, and obtain 2 x 50mm plastic 'end plugs' (screw on plug with rubber washers). Fit them into the top of your stabilator with cent
Hi all, Has anyone had fuselage skin deforming below the fuel cap and in line with the fuel 'cobra' inside plastic fuel inlet. I heard it was to do with temperature differences and dark cover over th
No can do!! Left the 4 holer for a 2 holer driven from the other seat. It would be slower but still get there via Fiji or Tahiti even Samoa for a little R and R, Kim!! Come on down, a bit colder thou